MIL-W-52125B
(c) Two plates, one on each side of the semitrailer at the kingpin, each with the following wording:
"Warning. This kingpin is reversible, having 2-inch and 3-1/2-inch throat
diameters. When coupling this semitrailer to the dolly or to a truck-tractor, be sure to use the correct end of the kingpin."
(d) One plate located in a conspicuous place on the dolly having the following wording: "Warning. Do not connect this dolly to any semitrailer unless a 3-1/2-inch
throat diameter kingpin is in place on the semitrailer."
3.24.2.2 Wiring diagram. A plate containing a schematic wiring diagram shall be mounted near the operator's position. The diagram shall show the physical location all wiring interconnections in the same relationship as when they are installed. Identification marking of wires, instruments, control devices, and connections shall be shown and shall coincide with markings on the items installed. Electrical symbols shall be in accordance with MIL-STD-15, WWhen additional electrical symbols are used for items not in MIL-STD-15, the meaning of the symbol shall be defined by a note on the diagram.
3.25 Treatment and painting. The portions of the unit normally painted shall be cleaned,
treated, and painted in accordance with MIL-T-704, type A.
3.26 Vehicle marking. The marking or the semitrailer shall be in accordance with
MIL-STD-642. The total weight and reduced weight for highway transport or the unit
(see 3.1.2), and the weight of each sectionalized component shall be marked on the side in such a manner as to be discernible. The prescribed tire pressure shall be marked near the tires. Lifting and tiedown attachments shall be marked "LIFT HERE" or "TIEDOWN HERE", as applicable. Marking of lifting and tiedown attachments for sections shall include the word: "SECTIONALIZATION".
3.27 Technical publications to accompany the unit. Such technical publications as are specified shall be furnished (see 6.2).
3.28 Repair parts and maintenance tools. Such repair parts and maintenance tools as are specified shall be furnished (see 6.2).
3.29 Toolbox. The unit shall be provided with one or more weatherproof toolbox(s) made of steel not less than 0.071 inch thick. The toolbox lid shall be mounted on hinges conforming to MS35829 with a 0.125-inch-diameter brass pin. The toolbox lid shall open to at least 90 degree
35
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business