A-A-52558A
TABLE I. Accessory dimensions.
|
Accessory
|
Length under collar (in.) |
Tool end (in.)
|
|
Chisel Moil point Pitch Spade |
13.5 to 14.5 13.5 to 14.5 16 to 19 16 to 19 |
2.75 to 3.25 wide Point 3 to 3.25 wide 5 to 6 wide |
3.13 Lubrication. All surfaces requiring lubrication shall be provided with a means for lubricating by an airline oiler. The oiler shall have the contractors standard commercial finish, which shall be smooth even surface, free from runs, sags or foreign material. The type of pneumatic system grease used for lubrication is identified by NATO Code Number G392.
3.14 Identification and marking. Identification and markings shall be permanent, legible and shall include as a minimum the Manufacturer’s identification code (CAGE), the Part or Identifying Number (PIN), and the National Stock Number (NSN).
3.15 Treatment and painting. The portion of the breaker and its components and parts normally painted shall be cleaned, treated, and painted for a one coat finish. The color shall conform to FED-STD-595, camouflage green 383, chip color 34094.
3.16 Chest. Unless otherwise specified (see 7.3), a chest made of steel or a material of equivalent strength not less than 0.07 in. (4 mm) in thickness shall be provided to hold the breaker, repair parts, and any accessories provided with the breaker. The chest shall have a continuous hinge extending the full length of the chest edge. The chest lids shall be held closed by not less than two hook type tension latches. A hose and lock shall be provided with the chest. Two lifting handles shall be provided, one located at each end of the chest.
3.17 Retainer. Each breaker shall be provided with a retainer that will prevent the accessory tool from becoming accidentally disengaged from the breaker. All surfaces that are subject to high temperatures shall be covered or guarded.
4. REGULATORY REQUIREMENTS. The offeror/contractor is encouraged to use recovered materials to the maximum extent practicable, in accordance with paragraph 23.403 of the Federal Acquisition Regulation (FAR).
5. PRODUCT CONFORMANCE PROVISIONS
5.1 Contractor certification. The contractor shall certify and maintain substantiating evidence that the product offered meets the salient characteristics of this CID and that the product conforms to the producer's own drawings, specifications, workmanship standards, and quality assurance practices. Items with known defects shall not be submitted for Government acceptance. The Government reserves the right to require proof of such conformance prior to the
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business